Off The Shoulder Tops…
…they’re everywhere this summer, aren’t they? I’m not one to usually bother with fashion trends. I’m not a big fan of buying or especially making clothes unless it’s something I really love and will wear loads. I do, however, like to get the maximum mileage out of a pattern, fabric and mostly out of my time. I thought about this trend for a while and came to the conclusion the off the shoulder top, or The ‘Bardot’ Top (or as my eldest called it Bar-Dot, worth writing a tutorial just for that!), could actually become a holiday summer basic.
I started with The Wendy Artisan Smock pattern and thought this would be a great little pattern hack to share. It does make the most perfect beach cover-up, just lengthen your pattern to get the leg coverage you are after. It would also make a delightful holiday dress with a little tie belt at the waist too. I’ve made it in an embroidered spot voile. Beautiful fabric – but be warned, it is quite sheer in the white if you are going down the dress route!
And I thought I should probably share it now as in England we’ve had more than 3 days of glorious sunshine this summer, and it’s now 50/50 (yes, I know that’s being optimistic) for the rest of August wether we get any more sunshine.
| SUPPLIES |
Wendy Artisan Top Pattern, Tape measure, Scissors, 1 metre (approx) of 2.5cm wide Elastic, Safety Pin
I recommend, as always, making a toile: it’s a test run in calico or a cheap fabric – you don’t want to waste your favourite fabric on a less the perfect top!
- Cut out your pattern using VERSION B (with no centre front neck opening) and don’t cut the binding pattern.
- NECKBAND: cut one long rectangle 7.5cm wide x SMALL: 123cm long / MEDIUM: 128.5 cm long / LARGE: 134cm long. It can be cut along the selvedge or across the fabric width on the straight grain.
Make up your top, following the instructions in the pattern: Attach pockets and sleeves, close side seams.
Cut neckline down by 4cm. Of course you could trim down your pattern pieces before cutting out your garment.
Press the neckband in half length wise
Join with a 1cm seam allowance to make the neck band into a loop, press the seam open
| Attach the band |
Pin neckband to RIGHT SIDE of the body. Depending on your fabric your neckline may ‘grow’ as it’s on the bias grain in places, just ease your garment onto the neckband.
Stitch your band to the body with a 1cm seam allowance. Leave a gap of about 5cm to thread your elastic through.
To get your elastic length: wrap elastic around shoulders where you want your top to sit, pulling slightly so it stretches, and mark. It needs to be tight enough to stay up but not so tight it cuts off the circulation and if it’s too tight it will ride up, too loose and it’ll drop down! Everyone’s measurement will vary as it depends on a lot of outside factors how stretchy is your elastic/ how tight are you comfortable with etc?
| Thread the elastic |
(This is the same process as the sleeve hem for the Smock) Attach a safety pin to your elastic to help thread it through the neckband channel. Once threaded lay the elastic with the ends flat on top of each other and stitch where you marked it earlier. Try your smock on and see how that elastic feels, now is the time to adjust if you need to. Once you are happy, make sure that elastic is stitched securely, and trim away excess elastic.
Then just stitch the gap closed, and neaten the raw seam allowance.
Now just enjoy the sun in your off the shoulder top, like the fashionista you are!